Premium RV Camper LED Awning Light Set (16 ft, RGB, IR Remote)
Updated June 19, 2026
This 16-foot RGB LED strip light is designed for mounting under RV or camper awnings. It uses 3528 SMD LEDs, is waterproof, and comes with a 44-key IR remote for color and mode control. The light connects to the vehicle's 12V system to provide customizable ambient lighting for outdoor camping and entertaining.
AI-generated content
Function and Design
The light set consists of a flexible strip housing 3528 SMD LEDs capable of producing red, green, blue, and millions of combined colors. The included 44-key IR remote allows users to select solid colors, adjust brightness, and cycle through dynamic modes such as strobe, fade, and flash. The strip is rated as waterproof, making it suitable for exterior use on awnings. The 16-foot length provides ample coverage for standard RV and camper awnings.
Compatibility and Fitment
This LED strip is designed for use on RVs, travel trailers, campers, and other recreational vehicles equipped with an awning. It mounts under the awning rail or along the side of the vehicle using the included adhesive backing or optional mounting clips. The light operates on a 12V DC electrical system, common in most RVs and campers. It can be wired directly to the vehicle's battery, a switched 12V circuit, or an existing awning light connection.
Installation Notes
Installation involves cleaning the mounting surface, peeling the adhesive backing, and pressing the strip into place. For a more secure fit, use the provided mounting clips and screws. Connect the positive and negative wires to a 12V source, ensuring correct polarity. A 2-amp inline fuse is recommended to protect the circuit. The IR remote requires line-of-sight to the receiver, so mount the receiver eye in a visible location. Pairing is automatic upon power-up.
Common Issues and Diagnosis
If the strip fails to light, check the 12V power supply and fuse. If only certain colors or segments are missing, inspect for damaged LEDs or solder joints. If the remote does not respond, replace the remote battery (typically CR2025) and ensure no obstructions block the IR signal. Water ingress at the ends or connections can cause corrosion; seal all exposed solder pads with silicone or heat shrink tubing.
